Biofilm assay EHEC biofilms were grown in polystyrene

96-well plates by plating 200 μl/well of 100 fold diluted overnight cultures in presence of 6.25, 12.5, 50, or 100 μg/ml of limonoids at 26°C for 24 h without shaking [23, 39]. For VS138 (ΔqseC) and VS179 (VS138 + qseBC) biofilms were quantified after 48 h growth in 96-well plates. The biofilms were quantified by staining with 0.3% crystal violet (Fisher, Hanover Park, IL) for 20 min. Extra stain was washed with phosphate buffer (0.1 M, pH 7.4) and dye associated with PSI-7977 cell line attached biofilm was dissolved with DMSO. An absorbance at 570 nm was used to quantify the total biofilm mass. In vitro adhesion assay Human epithelial Caco-2 cells were purchased from ATCC (Manassas, VA) and maintained in selleck chemical Dulbecco’s Minimal Essential Medium (DMEM) GDC 0032 concentration with nonessential amino acids and 10% fetal bovine serum without antibiotics. Caco-2 cells

were seeded at 1 × 105 cells/well in 6-well plates and infected with approximately 5 × 106 cells/well of freshly grown EHEC ATCC 43895 in presence or absence of 100 μg/ml isolimonic acid, ichangin, isoobacunoic acid, IOAG and DNAG. The plates were incubated for 3 h at 37°C in 5% CO2 environment. After completion of incubation, plates were washed 3× with sterile PBS to remove any loosely attached cells. Caco-2 cells were lysed with 0.1% Triton-X in PBS to release the bacteria and serial dilutions were plated on LB-agar and incubated at 37°C for 24 h. Colonies were counted after incubation period and presented as log10CFU/ml. Caco-2 cell survival assay Caco-2 cells (1 × 104/well) were seeded in 96-well plate and exposed to 100 μg/ml of isolimonic acid, ichangin, isoobacunoic Bumetanide acid, IOAG and DNAG for 6 h in humidified incubator at 5% CO2, 37°C. Cell survival was determined by measuring lactate dehydrogenase using CytoTox-ONE™ Homogeneous Membrane Integrity Assay (Promega Corp., Madison, WI). Quantitative PCR Relative transcript amount of selected genes (Table 2) was measured by qRT-PCR as described [23]. Briefly, overnight cultures of EHEC ATCC 43895 were diluted 100 fold with fresh LB medium or DMEM+10% FBS (referred as DMEM henceforth),

treated with limonoids (100μg/ml) or DMSO and grown further at 37°C, 200 rpm. Bacterial cells were collected at OD600 ≈1.0. RNA was extracted using RNeasy minikit (Qiagen Inc., Valencia CA) and converted to cDNA using MuLV reverse transcriptase enzyme and random hexamer in a Reverse-Transcriptase polymerase chain reaction (RT-PCR) [43] at 42°C for 1 h. PCR products were purified with QIAquick PCR-purification kit (Qiagen Inc.). Twenty five nanogram cDNA from each sample was amplified with 10 pmol target primers using SYBR Green PCR master mix (Life Technologies Corporation, Carlsbad, CA) for 40 amplification cycles. After completion of 40 PCR cycles, melt curve data was generated. All the measurements were done on three biological replicates consisting of three technical replicates each.