Two ligation probe reactions were needed to calculate the percentage of methylation, one of which contained the methylation-sensitive enzyme HhaI. Briefly, 200 ng of each sample was diluted to 5 μl with TE buffer and heated at 98°C for 10 min followed by incubation at 25°C for 5 min in a thermocycler. Following the addition of ligation probes, samples were first incubated at 98°C for 1 min and then at 60°C for 16–18 h to permit hybridization. Samples were split equally into two vials, each containing the same amount of DNA (volume 10 ul). Ligase-65 mix (Ligase-65 buffer, Ligase-65 enzyme and water) was added to the first

vial, and Ligase-Digestion mix (Ligase-65 buffer, Ligase- 65 enzyme, HhaI enzyme [Promega, Southampton, UK] and water) to the second. Both

samples were incubated at 49°C for 30 min, after CBL-0137 mouse which the GSK690693 in vivo Ligase enzyme was inactivated by heating at 98°C for 5 min. PCR buffer, deoxynucleoside 5-triphosphates (dNTPs) and Taq polymerase were added to the samples during preheating at 72°C. The PCR reaction was performed in a thermocycler preheated to 72°C, under the following conditions: 35 cycles at 95°C for 30 s, 60°C for Tozasertib ic50 30 s and 72°C for 60 s. The final incubation was at 72°C for 20 min. Amplification products were analyzed on an ABI-3130 DNA Analyzer (Applied Biosystems, Warrington, UK). Negative water controls were included to ensure no contamination. Internal validation was performed using unmethylated and methylated genomic DNA (Millipore, Watford, UK). Intrasample normalization was performed to address peak variations due to fluctuations in the assay run, such as amount of DNA, ploidy variations and PCR conditions, The relative peak height of each probe was determined by dividing the absolute peak height by the mean height of all 15 control probes. A methylation percentage for each probe was obtained using the following calculation, as described

previously [22]: $$ \mathrmMethylation\left(\%\right)=\frac\left(\mathrmpeak\;\mathrmheight\;\mathrmof\;\mathrma\;\mathrmgiven\;\mathrmprobe/\mathrmmean\;\mathrmheight\;\mathrmof\;\mathrmcontrol\;\mathrmprobe\mathrms\right)_\mathrmwith\kern0.5em \mathrmHha1\left(\mathrmpeak\;\mathrmheight\;\mathrmof\;\mathrma\;\mathrmgiven\;\mathrmprobe/\mathrmmean\;\mathrmheight\;\mathrmof\;\mathrmcontrol\;\mathrmprobe\mathrms\right)_\mathrmwith\mathrmout\kern0.5em #randurls[1\times 100 $$ Validation of MS-MLPA results Validation of MS-MLPA results was only performed for the three most significant genes: ATM, FHIT and MLH1. ATM and MLH1 were confirmed by pyrosequencing CpG analysis, while FHIT was validated by immunohistochemistry (IHC) staining. Twenty microliters of extracted DNA were converted using Epitect Bisulphite kit (Qiagen, Hilden, Germany) in accordance with the “Sodium Bisulphite Conversion of Unmethylated Cytosines in DNA” protocol.