Methods DAPT datasheet The La2NiMnO6 (LNMO) nanocomposites were synthesized by co-precipitation, using La(NO3)3·5H2O(99.5%), Ni(CH3COO)2·4H2O (98%), and Mn(CH3COO)4·4H2O(99%) as starting raw materials [16]. The raw powders were dissolved in deionized water in required stoichiometric proportions. The solutions were then poured together into a beaker and stirred in a magnetic blender at

80°C. After 2 h, aqueous ammonia solution was added to the container until a brown suspension took shape at a pH of approximately 8.5 [17]. After stirring for about 30 min, the suspension was ball-milled for 24 h with ethanol as a milling medium in order to mix the reactants well enough and then dried in a cabinet dryer at 80°C overnight to obtain the precursor samples. The dried powders were finally annealed in nitrogen atmosphere for 2 h at different temperatures in the range of 750°C~1,050°C.

The crystalline phase of LNMO nanocomposites was identified using the X-ray diffraction (XRD) technique. The X-ray diffractogram of all the samples from 10° to 70° at a scanning step of 0.02°/s was recorded using a Rigaku X-ray diffractometer (Rigaku Corporation, Tokyo, Japan) with Cu Kα radiation (λ = 1.54056 Ǻ ). The magnetic properties were measured using a vibrating sample magnetometer (PPMS-9, Quantum Design, Inc., San Diego, CA, USA) at room temperature under a maximum field of 30 kOe. The structural defects in the LNMO materials were selleck screening library Thalidomide investigated using a JEOL 4000EX high-resolution transmission electron microscope (HRTEM; JEOL Ltd., Tokyo, Japan) operated at 400 kV. The adsorption of BSA protein on nanoparticles was analyzed with a UV spectrophotometer (UV-2401 PC, Shimadzu Corporation, Kyoto, Japan) at room temperature. The aqueous solution

with a pH of about 7.4 contained 1.000 mg/ml BSA (purity >99%) before the adsorption, and for each measurement, 3.00 to 12.00 mg of La(Ni0.5Mn0.5)O3 nanoparticles was used as the adsorbent. The adsorbent was stirred ultrasonically in the BSA solution for 1 h at room temperature, which was put in static precipitation condition after 12 h to be measured. Results and discussion Figure 1 presents the XRD patterns for the whole samples with temperatures ranging from 750°C to 1,050°C. All of the diffraction peaks are identified and indexed according to the standard diffraction pattern data of LNMO powders. As seen from the scan (Figure 1), the LNMO nanoparticles have formed a pure https://www.selleckchem.com/products/bgj398-nvp-bgj398.html perovskite and exhibit random orientation [18, 19]. The lattice constants of LNMO are a = 5.467 Ǻ, b = 5.510 Ǻ, c = 7.751 Ǻ, and β = 91.12°.